Locate Automatic Movement - RESEARCH CONCEPTS RC4080 Integration Manual

RC4080 ACU

2.1.2.2.2.1.1 LOCATE Automatic Movement

Immediately following the satellite selection, the RC4080 will begin moving to the calculated position to
continue the locate process. The progress of the movement is displayed on the following screen.
A Z I M :
E L E V :
P O L :
M O V I N G T O S T A R T O F S C A N
The current angular values for AZ/EL/PL are displayed along with the target position for each axis in
parenthesis. The label for the current axis being moved will flash. Movement may be halted at any time
by pressing the <Stop> key. Halting movement will return the controller to the MANUAL mode.
If below the down limit in elevation, the first automatic movement will be in the elevation axis to ensure
that the mount is brought out of the elevation stow and down regions. If above the down limit, or after
moving above the down limit the RC4080 will then make an automated move to the first point of the
locate routine.
Chapter 5
1 . 7 ( 1 . 7 )
3 0 . 7 ( 4 5 . 0 )
- 7 . 1 ( - 7 . 1 )
28
D V B : 2 2 3 6 L O C A T E
S A T : G A L A X Y 2 8
< S T O P > H A L T
Support