HELVAR 924x Installation And User Manual page 43

12.4 Restoring TouchPanel
It is usual for each TouchPanel in a lighting system to have different content. For this reason, each backup also records the
serial number of the TouchPanel from which it has been made.
If you attempt to restore the backup to a different TouchPanel, you will be warned about the mismatched serial numbers as
a precaution, though you may continue with the restore. This allows you to configure one TouchPanel and use TouchPanel
Backup to copy the content to other TouchPanels, or to configure a replacement TouchPanel.
Restoring a backup will cause all existing TouchPanel content to be erased.
Before connecting the USB cable between the computer and TouchPanel:
• If the computer is a laptop or notebook, it must be removed from any docking station
• Remove any USB port expanders
• Remove the computer from any attached network connection
1. If your computer is not yet connected to TouchPanel via USB, connect it now.
2. From the Start menu or desktop shortcut, launch TouchPanel Backup.
3. Wait for TouchPanel Backup to establish communication with TouchPanel.
Press the Restore button.
4.
Choose a folder to restore, and then press the OK button.
5.
Press the Restore button to start the restore.
6.
7. TouchPanels Flash memory will be erased to make room for the restored content.
8. TouchPanel content will now be restored. When completed, TouchPanel will display the default screen.To learn about
the default screen, see section 8. Section 10.4 shows the meaning of the status graphics during backup and restore.
Press the Abort button at any time to stop the restore process.
9.
Do not delete the backup file until you are certain that TouchPanel is working correctly afer the
backup has been restored.
DALI control and load settings will not be restored. Backup and Restore therefore can not be used
to clone Dali devices and restore the settings to devices on anther panel.
41 Helvar | Data is subject to change without notice.
www.helvar.com 41