Table of Contents
Advertisement
5.7 Edit Load Properties
1. From
Main Menu select the following:
2.
to display a list of discovered Loads.
3.
to view the Pop up Menu.
4.
to enter edit mode. The load level display shows the groups to which each load belongs.
5. Choose the load you want to edit.
6.
to edit the Load properties.
7.
to display the Select Groups menu.
8. Tick the number of each Group to which you want this load to belong. If you want this load to be controlled only in
Broadcast mode, then assign the load to no groups at all. To learn more about Broadcast, see section 21.2.
9.
to select Load type.
10.
to save the changes.
5.8 Changing a Load Level manually
Levels are normally set by calling a scene that sets the required levels, but you can also set the level for
individual loads manually.
1. From
Main Menu select the following:
2.
to display a list of discovered Loads.
3.
and
to raise or lower a load level, or press within the load to set its approximate level.
The current level is shown in yellow, with a percentage
value to the left of the load. You should see the load
level in the system change immediately.
For example, if the load is a dimmer driving some lamps,
you should see the brightness of the lamps change
as you change the load level.
The current level is normally shown in YELLOW. If the
load is not present, the level is shown in GREY.
13 Helvar | Data is subject to change without notice.
www.helvar.com
13
Advertisement
Table of Contents
