Table of Contents
Advertisement
12.2 Connecting a computer to the USB port
1.
Ensure the software has been installed (see step 12.1)
2.
Insert a flat bladed screwdriver into one of the side
recesses of TouchPanel, and then twist the screwdriver
gently to lever off the bezel.
3.
With the bezel loosened, remove Panel by hand.
4.
Use the USB cable included with TouchPanel to
connect your computer to TouchPanel.
Each time TouchPanel is reconnected to your
computer it will take approximately ten seconds
for the computer to acknowledge the connection.
12.3 Backing up TouchPanel
Before connecting the USB cable between the computer and TouchPanel:
• If the computer is a laptop or notebook, it must be removed from any docking station
• Remove any USB port expanders
• Remove the computer from any attached network connection
If your computer is not yet connected to TouchPanel via USB, connect it now.
1.
From the Start menu or desktop shortcut, launch TouchPanel Backup.
2.
Wait for TouchPanel Backup to establish communication with TouchPanel.
3.
Press the Backup button:
4.
Choose a folder to which the backup will be written, and then press the OK button.
5.
Press the Backup button to start the backup. Section 10.4 shows the meaning of the status graphics during backup
and restore.
6.
Press the Abort button at any time to stop the backup process.
40
Helvar 924 LCD TouchPanel: Installation and User Guide
2.
3.
4.
www.helvar.com
Advertisement
Table of Contents
