Table of Contents
Advertisement
7.5 Editing Digidim Control Subdevice Properties (Sliders)
1. From
Main Menu select the following:
2.
to display the Controls menu.
3. Select the Control for which you want to edit the subdevice properties.
4. Select a slider to edit. (There is only one slider for 110 slider devices.)
5.
and then select a group to which this slider will belong.
6.
to change the button function. Choose one of the following settings:
*
to allow the slider to issue levels to minimum, but not to off.
*
to low the slider to issue levels down to off.
*
to set the slider to Not Used. The slider will have no function.
7.
or
to set the slider to linear or logarithmic curve mode. Logarithmic mode is best for DALI ballasts and
dimmers. Linear mode is best for Imagine dimmers.
8.
to save changes.
7.6 Editing Digidim Control Subdevice Properties (Multisensor 312 PIR)
The PIR sensor is configured in the same way as a button, but with the addition of special features for Multisensor 312. To
learn how to configure the PIR sensor, see section 7.3.10. To learn about PIR special features, see below.
The constant light subdevice, if enabled, is presented as a constant light in and constant light out. The constant light in subdevice
shares its group with the PIR sensor, so changing the group of the PIR will also change the constant light in, and vice versa.
The constant light in sub-device should be the same group as other button controls. The constant light out subdevice should
have its group set to contain the loads to be controlled. The constant light module of the multisensor will then listen for
requests in the in-group, and use this information to decide how to control the loads of the out-group.
To store a constant light level into a scene, set the light level to the desired level, using any suitable method
(adjust the light from TouchPanel, a remote control, another control, or by adjusting the curtains/blinds in the
room). Once the desired light level has been achieved, perform a scene store (for example, by holding the relevant
scene button in for more than the default scene store time). Once stored, recalling this scene will cause the lights
to be adjusted automatically as the daylight varies, thus maintaining the stored light level.
To enable or disable the constant light feature, see section 7.3.11.
1. From
Main Menu select the following:
2.
to display the Controls menu.
3. Select Control from which you want to edit subdevice properties and select a button to edit.
4.
and then select a group to which the PIR will belong.
20
Helvar 924 LCD TouchPanel: Installation and User Guide
www.helvar.com
Advertisement
Table of Contents
