Ibr Lever (If Equipped); Engine Cut-Off Switch - Sea-doo GTXPRO 130 Series Operator's Manual

3) iBR Lever (if equipped)

The iBR lever on the LH handlebar can
electronically command:
– Brake
– Reverse
– Neutral.
NOTE: A minimum of 25% of iBR lever
stroke is required to activate iBR func-
tions.
219001878-012_a
TYPICAL
1. iBR lever
2. Lever rest position
3. 25% stroke required to activate iBR
functions
4. Operating range
At speed above 14 km/h (9 MPH),
pulling the iBR lever will engage the
brake.
NOTE: If water current is 14 km/h
(9 MPH) or above, the reverse can not
be engaged as the speed threshold for
the reverse is exceeded.
At speed below 14 km/h (9 MPH),
pulling the iBR lever will engage re-
verse.
When the iBR lever is released after
braking or reverse operation, the neu-
tral is engaged.
WARNING
If throttle lever is still pulled in
when releasing the iBR lever, for-
ward movement will be initiated
after a short delay. If forward ac-
celeration is not desired, release
the throttle lever.
NOTE: The neutral position can be fine
tuned by trimming the iBR system.
Refer to
for detailed instructions.

4) Engine Cut-Off Switch

The engine cut-off switch is located in
the middle of the handlebar.
219001970-004_a
TYPICAL
1. Engine cut-off switch
To allow engine starting, the tether
cord cap must be securely snapped to
the engine cut-off switch.
Always attach the tether cord clip
to the operator's personal flota-
tion device (PFD) or wrist (wrist
strap required).
smo2009-002-115_a
TYPICAL
1. Tether cord cap on the engine cut-off switch
2. Tether cord secured to operator's PFD
_______________
OPERATING INSTRUCTIONS
WARNING
CONTROLS
44