Moto" Seat Post Receiver; Moto" Seat Post Release Lever (If So Equipped); Kart Seat Lever (If So Equipped) - Sea-doo 2005 3D RFI Operator's Manual

26) "Moto" Seat Post
Receiver
The receiver locks the seat post in-
to position on the deck. For instruc-
tions, refer to "MOTO" SEAT INSTAL-
LATION/STOWAGE above.
1. Receiver
27) "Moto" Seat Post
Release Lever (if so
equipped)
The lever releases the seat post from
within the seat. It is used also to re-
lease the post from its receiver on the
deck. For instructions, refer to "MO-
TO" SEAT INSTALLATION/STOWAGE
above.
28) Kart Seat Lever
(if so equipped)
The lever releases the latch locking the
seat on the deck.
WARNING
Only remove or install the kart seat
when the watercraft is out of the
water or docked securely on calm
water.
______________________
44
Seat Installation
Before installing or removing kart
seat:
Only install or remove the kart seat
when the watercraft is out of the
water or docked securely on calm
water.
With the seat slightly angled forward,
insert the seat front tab into the anchor
plate on the deck.
Line up the pin located underneath the
seat with the hole in the deck, then
push down to latch the seat.
1. Kart seat
2. Anchor plate
3. Insert pin in hole
Always make sure that the seat
is installed properly and securely
locked in place before operating
the watercraft.
If you cannot rest your feet com-
fortably on the footr ests, install the
footrest spacers (refer to your autho-
rized Sea-Doo dealer for more infor-
mation). This will help achieve a more
stable riding position.
www.SeaDooManuals.net
WARNING
WARNING