Variable Trim System (Vts) Button (If So Equipped); Shift Lever - Sea-doo GTI Operator's Manual

smo2006-002-001_a
1. Engine start/stop button
5) Variable Trim
System (VTS) Button
(if so equipped)
Located just
start/stop button, this button is used
to change pump jet nozzle position
and to adjust ride to suit watercraft
load and water conditions.
smo2006-002-020_a
TYPICAL
1. VTS button
A VTS position indicator is included in
the information center gauge. See IN-
FORMATION CENTER in this section.
below the engine

6) Shift Lever

A push-pull lever:
– forward
– neutral
– reverse.
Shift lever should only be used
when the engine is idling and wa-
tercraft is completely stopped. Do
not use as a grab handle.
Only use reverse at slow speed
and for the shortest time possible.
Always ensure the path behind
is clear of objects and persons
including children playing in shal-
low water.
CAUTION: Never rev the engine at
high RPM in reverse.
From the forward position, pull the
lever to reverse. Push back to go to
forward. Always set in forward when
finished. To find the neutral, set in re-
verse then push back until the water-
craft stops moving backwards.
TYPICAL
1. Forward position
_____________________
WARNING
WARNING
41