Engine Coolant - Sea-doo GTXPRO 130 Series Operator's Manual

MAINTENANCE PROCEDURES
NOTICE
Ensure that oil filler cap is
tighten properly. Otherwise engine
oil can spill out.
Engine Oil Change and Oil Filter
Replacement
The oil change and filter replacement
may be performed by an authorized
Sea-Doo dealer, repair shop, or person
of your own choosing.

Engine Coolant

Recommended Engine Coolant
XPS RECOMMENDED COOLANT
Extended life pre-mixed coolant
If THE RECOMMENDED XPS
COOLANT IS NOT AVAILABLE
Use a low silicate, extended life
ethylene-glycol premixed coolant
(50%-50%) specifically formulated for
internal combustion aluminum engines.
NOTICE
Always use ethylene-gly-
col antifreeze containing corrosion
inhibitors specifically for internal
combustion aluminum engines.
To prevent antifreeze deterioration, al-
ways use the same brand and grade.
Never mix different brands or grades
unless cooling system is completely
flushed and refilled.
Engine Coolant Level
WARNING
Check coolant level with engine
cold. Never add coolant when en-
gine is hot.
CAUTION Many components
in the engine compartment may be
very hot. Direct contact may result
in skin burn.
Remove seats.
Locate the expansion tank cap.
______________
85
219002053-003
With watercraft on a level surface,
coolant level should be between MIN.
and MAX. marks on coolant reservoir
when engine is cold.
219001878-052_a
COOLANT EXPANSION TANK
1. Level between marks when engine is cold
NOTE: The watercraft is level when
it is in water. When on a trailer, raise
trailer tow pole and block in this posi-
tion when bumper rail is level.
Add coolant, see
ENGINE COOLANT
to adjust coolant level between marks
as required. Use a funnel to avoid
spillage. Do not overfill.
Properly tighten the expansion tank
cap. Reinstall seats.
NOTE: A cooling system that fre-
quently requires coolant is an indica-
tion of leaks or engine problems. See
an authorized Sea-Doo dealer.
RECOMMENDED
for specification,