How To Use The Variable Trim System (Vts) (If Equipped) - Sea-doo GTXPRO 130 Series Operator's Manual

Table of Contents

Advertisement

OPERATING INSTRUCTIONS
NOTE: Be careful to gradually actuate
the iBR lever to adjust intensity of the
braking force and simultaneously re-
lease the throttle lever.
CAUTION When braking, rid-
ers must brace themselves against
the deceleration force to prevent
from moving forward on the water-
craft and losing balance. The oper-
ator shall always keep both hands
on the handlebars, and all passen-
gers should maintain a firm grip of a
handhold or the waist of the person
in front of them.
WARNING
Stopping distance will vary de-
pending on initial speed, load,
wind, number of riders, water con-
ditions, and the amount of braking
power commanded by the oper-
ator. Always adjust your riding
style accordingly.
When the watercraft slows to less than
14 km/h (9 MPH), braking mode ends
and reverse mode is engaged. Re-
lease the iBR lever once the watercraft
is stopped. Otherwise, a rearward
movement will be initiated.
CAUTION As the watercraft
slows to a stop, the wake created
by the watercraft will catch up and
tend to push the watercraft forward.
Ensure there are no obstacles or
bathers in the direction of travel.
If the throttle lever is still pulled in
when releasing the iBR lever, the wa-
tercraft will accelerate forward after a
short delay. Acceleration will be pro-
portional to the throttle lever position.
WARNING
If forward acceleration is not de-
sired when the brake lever is re-
leased, release the throttle lever.
______________
69
When at speed and the brake is first
applied, a plume of water will shoot up
in the air behind the watercraft which
may cause the operator of a following
watercraft to momentarily loose sight
of your PWC.
WARNING
– It is important to inform the
operator of a watercraft who
intends to follow in a convoy
formation, of the braking and
maneuvering capability of your
PWC, what the plume of water
indicates, and that a greater dis-
tance must be maintained be-
tween watercrafts.
– Be aware that other boats fol-
lowing or operating in close
proximity may not be able to
stop as quickly.
Braking in a Turn
Throttle must be applied for turning to
ensure directional control. However
braking can be initiated during a turn
using the iBR lever as previously de-
scribed. Get ready to maintain your
balance while the wake is crossing
your PWC.
CAUTION As the watercraft
slows to a stop while braking in a
turn, the wake created by the water-
craft will catch up and tend to push
the watercraft sideways. Be pre-
pared to maintain balance as the
wake crossed the watercraft.
How to Use the Variable
Trim System (VTS) (if
equipped)
The
variable
changes the vertical position of the jet
pump nozzle to provide the operator
with a fast, effective system to com-
pensate for load, thrust, riding position
and water conditions. Correctly ad-
justed, it can improve handling, reduce
trim
system
(VTS)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gtx pro 130Gtx pro 130 ibr

Table of Contents