Mounting The Grinding Wheel / Cutting Disc - Clarke METALWORKER CAG121 Operating & Maintenance Instructions

Mounting the Grinding Wheel / Cutting Disc

( i )
Unscrew and remove the outer flange :
1
If it is tight, lock the spindle by pressing
the Spindle Lock button and use the tool
supplied to turn the flange to break the
seal. It may then be screwed off by
hand.
2
Mount the Grinding Wheel : as shown in
the diagram. The Grinding wheel
supplied is a Depressed Centre' type.
Mount with the depressed centre
3
towards the motor.
Screw on the Outer Flange : with the
centre boss facing inwards ensuring the
wheel sits snugly over the raised boss on
the inner flange.Tighten the flange using
the tool provided, locking the spindle by
pressing the Spindle Lock button, and
taking care to ensure the wheel is still
sitting snugly, centred over the flange
bosses. Do Not over-tighten the outer
flange.
IMPORTANT ! Fig (2) shows the set up for a grinding wheel.
WHEN ATTACHING A CUTTING DISC YOU MUST REVERSE THE OUTER FLANGE
Using the Grinder
IMPORTANT! DO NOT plug the tool in to the mains, unless you have ensured it is switched
OFF and the guard is set to the desired position.
Hold the Grinder firmly in both hands. The hand holding the body will control the ON/
OFF switch, whilst the other hand grasps the handle and guides the tool over the
workpiece. Hold at 15 - 30
To Start the Motor press the switch to "I". To Stop the Motor press the switch to "0".
Allow the tool to do the work, do not force the wheel on to the workpiece.
IMPORTANT! BE AWARE at all times, the tool can be very dangerous if not used properly
Figure (2) Mounting Discs
0
from the workpiece.
- 7 -