Related Manuals for Clarke CAG232
Summary of Contents for Clarke CAG232
- Page 1 9” (230mm) 9” (230mm) ANGLE GRINDER ANGLE GRINDER Model No. CAG232 OPERATING & MAINTENANCE INSTRUCTIONS © 1104...
-
Page 2: Table Of Contents
Part No............6470097 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machine’s data plate CONTENTS Specifications ................ - Page 3 Thank you for selecting this CLARKE 230mm (9”) Angle Grinder, designed for use in a light industrial environment. Before attempting to use the tool, please read this leaflet thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the Angle Grinder giving you long and satisfactory service.
-
Page 4: Additional Precautions For Angle Grinders
NEVER force the tool. It will do a better and safer job at the rate for which it was designed. ALWAYS USE A FACE OR DUST MASK if operation is particularly dusty. DRUGS, ALCOHOL, MEDICATION. Do not operate tool while under the influence of drugs, alcohol or any medication. - Page 5 Keep the mains cable well away from the tool and ensure an adequate electrical supply is close at hand so that the operation is not restricted by the length of the cable. Switch the tool OFF immediately the task is completed and be aware that the wheel/disc will continue to rotate for a period of time after switching off.
-
Page 6: Electrical Connections
ELECTRICAL CONNECTIONS This model is provided with a 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a standard, domestic electrical supply. Should the plug need changing at any time, ensure that a plug of identical specification is used. IMPORTANT: This appliance is of Double Insulation construction No earth conductor is provided. -
Page 7: Features
FEATURES (ref. fig.2) 1.Trigger Safety Button. To operate the trigger it is first of all necessary to press the trigger safety button, Press the button then pull the trigger to start, ensuring the machine is held firmly and away from the body. 2.Spindle Lock Button. -
Page 8: Assembly
The disk supplied with this machine is suitable for grinding steel. Consult your Clarke dealer if you need a disk for cutting or grinding other materials...such as masonry etc. -
Page 9: Operation
3.Hand Grip (3-position) A threaded hole, on the top, left and right hand side of the gear housing, is provided so that the hand grip may be screwed in, as required, to provide left or right hand control of the tool. OPERATION Re: Fig.3 IMPORTANT! For safety, ensure the wheel is perfectly secure and the guard is set to... -
Page 10: Maintenance
MAINTENANCE IMPORTANT: Before carrying out any maintenance tasks, ALWAYS disconnect the tool from the mains electrical supply. Before Each Use Always inspect the tool before use, and ensure it is in top condition. Ensure air vents are clear, use compressed air at low pressure, to clean the tool where possible. - Page 11 Inner Flange HTCAG23206 Flange Tool HTCAG23207 Grinding Wheel/Cutting Disc (See below) The following Grinding Wheels/ Cutting Discs are available from your Clarke dealer. Metal Grinding (DPC) 230mm x 6mm thickness Part No. 6470720 Metal Cutting (Flat) 230mm x 3mm thickness 6470790...