Troubleshooting; Specification - Clarke METALWORKER CAG121 Operating & Maintenance Instructions

Troubleshooting

Problem
Tool will not operate
Motor runs but disc
does not turn
Heavy internal
sparking
Motor gets hot
ensure
Excessive vibration

Specification

Model No ................................................................. CAG 121
Part No ..................................................................... 6470088
Supply Voltage ........................................................ 230 V AC, 50 Hz, 1 Phase
Fuse Rating .............................................................. 13A
Insulation Class ........................................................ E
No Load Speed ....................................................... 11,000 RPM
Maximum Cutting Wheel Diameter ..................... 115mm
Cutting Wheel Bore ................................................. 22mm
Drive Spindle Thread ............................................... M14
Tool Weight .............................................................. 1.6kg
Possible Cause
1. No supply
2. Switch is faulty
3. Brushes badly worn
4. Fuse blown
5. Motor faulty
1. Flange nut not tight
2. Gear shaft or key
broken
1. Faulty motor
2. Badly worn brushes
1. Work load too heavy
2. Low supply voltage
1. Disc not mounted
correctly or is damaged
2. Bearings worn
Repair
1. Check supply and rectify
where necessary.
2. Consult your Clarke dealer
3. Check and replace if necessary
4. Check and replace if necessary
If condition persists, consult your
dealer
5. Consult your Clarke dealer.
1. Tighten flange nut
2. Consult your Clarke dealer
1. Consult your Clarke dealer
2. Renew brushes (see p.8)
1. Reduce force applied to tool
2. Ensure supply voltage is correct.
If extension cable is used,
it is of the correct value, and is
fully unreeled
1. Check and rectify
2. Consult your Clarke dealer
- 9 -