Related Manuals for Clarke CAG115C
Summary of Contents for Clarke CAG115C
- Page 1 4½” (115mm) ANGLE GRINDER Model No. CAG115C OPERATING & MAINTENANCE INSTRUCTIONS 0398...
-
Page 2: Table Of Contents
Thank you for selecting this CLARKE 115mm (4½”) Angle Grinder, designed for DIY and light workshop use only. Before attempting to use the tool, please read this leaflet thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the Angle Grinder giving you long and satisfactory service. - Page 3 ALWAYS ensure that ADEQUATE LIGHTING is available. A minimum intensity of 300 lux should be provided. Ensure that lighting is placed so that you will not be working in your own shadow. CHECK for DAMAGE. Before using the tool, any damaged part should be checked to ensure that it will operate properly and perform its intended function.
-
Page 4: Additional Precautions For Angle Grinders
ADDITIONAL PRECAUTIONS FOR ANGLE GRINDERS It is strongly advised that you wear ear protectors/defenders as the noise level during operation, depending upon the work being carried out, can exceed safe working levels. Always wear a good pair of industrial gloves to avoid potential injury from sparks and debris. -
Page 5: Electrical Connections
ELECTRICAL CONNECTIONS This product is provided with a 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a standard, domestic electrical supply. Should the plug need changing at any time, ensure that a plug of identical specification is used. IMPORTANT: This appliance is of Double Insulation construction and no earth cond-... -
Page 6: Assembly
WARNING: NEVER press the spindle lock button when starting the tool, and NEVER press the button when the tool is operating. DO NOT press button until the wheel/disc has stopped completely Fig 1. 3. Quick Change Guard. The guard is capable of rotating about its axis. -
Page 7: Operation
OPERATION IMPORTANT: DO NOT plug the tool in to the mains, unless you have ensured it is switched OFF and the guard is set to the desired position. The hand holding the body will control the ON/OFF switch, whilst the other hand grasps the hand grip and guides the tool over the workpiece. -
Page 8: Troubleshootiing
Remedy Tool will not operate 1. No Supply 1. Check Supply and rectify where necessary. 2. Switch is faulty 2. Consult your Clarke dealer 3. Brushes badly worn 3. Check and replace if necessary 4. Fuse blown 4. Check and replace if necessary. -
Page 9: Spare Parts
PARTS & SERVICE FAX - 0181 558 3622 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice.