Related Manuals for Clarke CAT 89
Summary of Contents for Clarke CAT 89
- Page 1 DIE GRINDER DIE GRINDER MODEL NO: CAT 89 PART No: 3110845 OPERATION & MAINTENANCE INSTRUCTIONS 0902...
-
Page 3: Table Of Contents
CONTENTS Specifications ................4 Guarantee ................5 Safety Precautions ..............6 Operating Instructions ............7 Maintenance ................7 Parts List & Diagram ............... 8 Vibration Emmisions ...... refer to notes on page 9 Blank Page ................10 Declaration of Conformity ..........11 MODEL No: CAT89 DESCRIPTION:... -
Page 4: Specifications
Overall Length ............... 5-1/2” Please note that the details and specifications contained herein are correct at the time of going to print. However CLARKE International reserve the right to change specifications at any time without prior notice. Always consult the machines data plate... -
Page 5: Guarantee
PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com ACCESSORIES A wide range of Airline accessories is available, including Filter/Regulators, Lubricators, High Pressure Hoses from 5 to 100 Metres, etc. Contact your CLARKE dealer for further information, or CLARKE International Sales Department on 01992 565300... -
Page 6: Safety Precautions
They add weight a ¼” hose adapter, (A whip hose with Quick and could fail due to vibration. Fit coupling is available from your CLARKE DO NOT over-reach. Keep your proper dealer). then connect the other end to the footing and balance at all times. -
Page 7: Operating Instructions
NOTE: If the grinder is to be stored, or is idle for longer than 24 hours, run a few drops of Clarke Air Grinding stones come with two different size Line Oil into the air inlet, and run the tool for 5 shafts 1/8”... -
Page 8: Parts List & Diagram
PARTS DIAGRAM PARTS & SERVICE TEL: 020 8988 7400 e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com... - Page 9 PARTS LIST Index No Part No Description KL89001 Double Ended Spanner KL89002 Double Ended Spanner KL89003 Collet Nut KL89004 Collet KL89005 Housing Cap KL89006 Retainer KL89007 Spindle KL89009 Ball Bearing KL89010 Front End Plate KL89011 Ball KL89012 Cylinder KL89013 ‘O’ Ring KL89014 Rotor KL89015...
-
Page 10: Blank Page
HAND-ARM VIBRATION Employers are advised to refer to the HSE publication “Guide for Employers”. All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 hertz is potentially damaging and is most hazardous in the range from about 5 to 20 hertz.