Advertisement
150mm Bowl Baby Camera Tripod Stand Setup
•
Loosen all three adjustment knobs to set the
desired height of the Stand.
NOTE: One-stage telescopic design with friction
knob extends up to 6 inches to capture
low-angle shots, and conversely, it can be easily
extended up to 34 inches for greater elevation.
•
After setting the height, tighten the knobs to
secure the Stand, as shown in the image.
NOTE: Locking pins on each leg secures the
adjusted
height,
preventing
retracting under load.
•
Unlock the red knob to adjust the Tripod's legs
according to your requirement.
•
After adjusting the Tripod legs, re-lock the
knob, as shown in the image.
•
Mount the Tripod on the aluminum Spreader
by equally aligning them.
•
After mounting the Tripod, properly secure it
using the rubber gripper.
them
from
3
Advertisement
