Table of Contents
Advertisement
When your dish is ready, switch off the appliance using
the ÿ On/Off button.
Changing
You can change the settings as usual.
To change the temperature or the duration, touch the
corresponding text field and change using the rotary
selector. The change is adopted immediately.
To change the type of heating, interrupt the operation
beforehand using the l Start/Stop button.
Sous-vide
Sous-vide is a type of low-temperature cooking during
which vacuum-sealed food is cooked at low
temperatures between 50-95 °C and 100% steam.
Sous-vide is suitable for meat, fish, vegetables and
desserts.
A chamber vacuum-packing machine is used to heat-
seal the food in special air-tight, heat-resistant cooking
bags. The protective envelope retains the nutrients and
flavours.
Notes
If the water tank runs dry while sous-vide cooking,
■
the operation is interrupted.
During sous-vide cooking, more condensate forms
■
on the cooking compartment floor than for other
cooking methods.
Starting
Caution!
Risk of damage to kitchen units
Only fill the water tank once for sous-vide cooking. Do
not fill the water tank a second time. If you do this, large
volumes of water will accumulate on the cooking
compartment floor. The water may leak out of the
cooking compartment.
Fill the water tank.
1.
Touch the Menu field.
2.
Touch the "Steam" text field.
3.
Touch the "Sous-vide" text field.
4.
The temperature is highlighted.
Use the control ring to set the temperature.
5.
Touch the "Cook. time" text field and set the cooking
6.
time.
A cooking time is always required for the
Note:
steam-assisted types of heating.
Press the Start/Stop button l to start.
7.
The appliance will start heating.
:
Warning – Risk of scalding!
Hot water collects on the vacuum-sealing bag during
cooking. Use an oven cloth to carefully lift the vacuum-
sealing bag, so that the hot water runs off into the
universal pan or the cooking container. Then use the
oven cloth to carefully remove the vacuum-sealing bag.
Once the cooking time has elapsed, an audible signal
will sound. The appliance will stop heating. The cooking
time 00 m 00 s will be shown on the display.
When your dish is ready, use the On/Off button ÿ to
switch off the appliance.
Changing
You can change the settings as usual.
To change the temperature or the duration, touch the
corresponding text field and change using the rotary
selector. The change is adopted immediately.
To change the type of heating, interrupt the operation
beforehand using the l Start/Stop button.
Filling the water tank
The water tank is located behind the control panel.
Before starting an operation with steam, open the
control panel and fill the water tank with water.
Make sure that you have set the water hardness range
correctly. ~ "Basic settings" on page 25
:
Warning – Risk of injury and risk of fire!
Only fill the water tank with water or with the descaling
solution that is recommended by us. Do not pour any
flammable liquids (e.g. alcoholic drinks) into the water
tank. Due to hot surfaces, vapours from flammable
liquids may catch fire in the cooking compartment
(explosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
:
Warning – Risk of burns!
The water tank may heat up while the appliance is in
operation. Wait until the water tank has cooled down
after the previous appliance operation. Remove the
water tank from the water tank recess.
Caution!
The appliance may become damaged due to the use of
unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
uncarbonated mineral water.
Caution!
Malfunctions may occur when using filtered or
demineralised water.
The appliance may request that you top up the water
tank even though it may be full, or operation with steam
is cancelled after approx. two minutes.
If required, mix filtered or demineralised water with the
bottled non-carbonated mineral water with a ratio of
one to one.
Notes
If your water is very hard, we recommend that you
■
use softened water.
If you use only softened water, you can set your
■
appliance to the "softened" water hardness range.
If you use mineral water, set the water hardness
■
range to "4 very hard".
If you use mineral water, you must only use non-
■
carbonated mineral water.
Touch the v field.
1.
The control panel is pushed forwards automatically.
Pull the control panel forwards with both hands and
2.
then push it upwards until it locks into place (Fig.
Steam
en
).
!
19
Advertisement
Table of Contents
