Schematic And Layout - Texas Instruments ADS1110EVM User Manual

This chapter contains the complete bill of materials, schematic diagram, and
printed circuit board (PCB) layout for the ADS1110EVM.
The schematic diagram is shown in Figure 3−1 on page 3-2. The top
(component) side layout is shown in Figure 3−2 on page 3-3. The bottom
(solder) side layout is shown in Figure 3−3 on page 3-3. The bill of materials
is shown in Table 3−1 on page 3-4.
Note:
Board layouts are not to scale. These are intended to show how the board
is laid out; they are not intended to be used for manufacturing ADS1110EVM
PCBs.
Topic
3.1 Schematic . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 Board Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.3 Bill of Materials . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Schematic and Layout

Schematic and Layout
Chapter 3
Page
3-2
3-3
3-4
3-1