Declaration Of Conformity; Product Disposal; Warranty Registration; Imo And Solas - Teledyne JCU-3 Installation & Operation Instructions

Note:
In areas of extreme EMC interference, some slight interference may be
noticed on the product. Where this occurs the product and the source of
the interference should be separated by a greater distance.
For optimum EMC performance we recommend that wherever possible:
• FLIR equipment and cables connected to it are:
– At least 1 m (3.3 ft) from any equipment transmitting or cables carrying
radio signals e.g. VHF radios, cables and antennas. In the case of SSB
radios, the distance should be increased to 2 m (6.6 ft).
– More than 2 m (6.6 ft) from the path of a radar beam. A radar beam
can normally be assumed to spread 20 degrees above and below the
radiating element.
• The product is supplied from a separate battery from that used for engine
start. This is important to prevent erratic behavior and data loss which can
occur if the engine start does not have a separate battery.
• FLIR specified cables are used.
• Cables are not cut or extended, unless doing so is detailed in the
installation manual.
Note:
Where constraints on the installation prevent any of the above
recommendations, always ensure the maximum possible separation
between different items of electrical equipment, to provide the best
conditions for EMC performance throughout the installation

Declaration of conformity

FLIR Belgium BVBA declares that the M100/M200 Series cameras, part
numbers E70431, E70432, E70353, E70354 are in compliance with the
Radio Equipment Directive 2014/30/EU.
The original Declaration of Conformity certificate may be viewed on the
relevant product page at www.flir.com/support.
8

Product disposal

Dispose of this product in accordance with the WEEE Directive.
The Waste Electrical and Electronic Equipment (WEEE) Directive requires
the recycling of waste electrical and electronic equipment which contains
materials, components and substances that may be hazardous and present
a risk to human health and the environment when WEEE is not handled
correctly.
Equipment marked with the crossed-out wheeled bin
symbol indicates that the equipment should not be
disposed of in unsorted household waste.
Local authorities in many regions have established
collection schemes under which residents can dispose of
waste electrical and electronic equipment at a recycling
center or other collection point.
For more information about suitable collection
points for waste electrical and electronic equipment
in your region, refer to the Raymarine website:
www.raymarine.eu/recycling.

Warranty registration

To register your FLIR product ownership, please visit
register online.
It is important that you register your product to receive full warranty benefits.
Your unit package includes a bar code label indicating the serial number of
the unit. You will need this serial number when registering your product
online. You should retain the label for future reference.

IMO and SOLAS

The equipment described within this document is intended for use on
leisure marine boats and workboats NOT covered by International Maritime
Organization (IMO) and Safety of Life at Sea (SOLAS) Carriage Regulations.

Technical accuracy

To the best of our knowledge, the information in this document was correct
at the time it was produced. However, FLIR cannot accept liability for
any inaccuracies or omissions it may contain. In addition, our policy
of continuous product improvement may change specifications without
notice. As a result, FLIR cannot accept liability for any differences
www.flir.com and