Table of Contents
Advertisement
CHAPTER 1: IMPORTANT
INFORMATION
Safety warnings
Warning: Product installation and operation
• This product must be installed and operated in accordance
with the instructions provided. Failure to do so could result
in personal injury, damage to your vessel and/or poor
product performance.
• Certified installation by an approved installer is
recommended. A certified installation qualifies for
enhanced product warranty benefits. Contact your dealer
for further details, and refer to the separate warranty
document packed with your product.
Warning: Switch off power supply
Ensure the vessel's power supply is switched OFF before
starting to install this product. Do NOT connect or disconnect
equipment with the power switched on, unless instructed in
this document.
Product warnings
Warning: Product grounding
Before applying power to this product, ensure it has been
correctly grounded, in accordance with the instructions
provided.
Warning: Positive ground systems
Do not connect this unit to a system which has positive
grounding.
Important information
Warning: Potential ignition source
This product is NOT approved for use in hazardous/flammable
atmospheres. Do NOT install in a hazardous/flammable
atmosphere (such as in an engine room or near fuel tanks).
Caution: Power supply protection
When installing this product ensure the power source is
adequately protected by means of a suitably-rated fuse or
thermal circuit breaker.
Regulatory notices
Water ingress
Water ingress disclaimer
Although the waterproof rating capacity of this product meets the stated
standard (refer to the product's Technical Specification), water intrusion
and subsequent equipment failure may occur if the product is subjected
to commercial high-pressure washing. FLIR will not warrant products
subjected to high-pressure washing.
Disclaimer
FLIR does not warrant that this product is error-free or that it is compatible
with products manufactured by any person or entity other than FLIR.
FLIR is not responsible for damages or injuries caused by your use or
inability to use the product, by the interaction of the product with products
manufactured by others, or by errors in information utilized by the product
supplied by third parties.
EMC installation guidelines
FLIR equipment and accessories conform to the appropriate Electromagnetic
Compatibility (EMC) regulations, to minimize electromagnetic interference
between equipment and minimize the effect such interference could have
on the performance of your system
Correct installation is required to ensure that EMC performance is not
compromised.
7
Advertisement
Table of Contents
Troubleshooting
