Resetting The Keypad To Factory Defaults - Teledyne JCU-3 Installation & Operation Instructions

5. In the left-hand menu, click CAMERAS.
The camera pairing page is displayed.
6. Click [Discover] to find all compatible cameras that are on the same
network as the JCU-3.
The [DISCOVERED CAMERAS] list shows all compatible thermal
cameras that were discovered.
7. In the [DISCOVERED CAMERAS] list, select the camera you wish to pair
with the JCU-3, and click [Add–>].
The keypad's LED backlight flashes twice to indicate that pairing was
successful. For further information on the keypad's LED status, refer to
the following section: p.42 — Keypad status
The chosen camera is now paired with the JCU-3 keypad, and moved
to the [SELECTED CAMERAS] list. Repeat this step for any additional
cameras that you want to pair with the JCU-3. When you leave the
JCU-3 Configuration pages the JCU-3 keypad remembers the selected
cameras, and will cycle through the camera list (if you paired the keypad
to more than one camera) when you click the [NEXT CAMERA] button
on the keypad.
8. Optionally, before leaving the JCU-3 Configuration pages, you can
manually connect to one of the cameras in the [SELECTED CAMERAS]
40
list, to confirm that you can control the camera with the JCU-3 keypad.
In the [camera connect] list, highlight the camera you want to connect
to and click [Select]
The JCU-3 keypad connects to the camera; you can now control the
camera from the keypad. The top-right of the [CAMERAS] page (directly
underneath the [Logout] button) shows [Camera Connected:], and lists
the name of the connected camera.
9. When you have finished pairing cameras and testing connections, click
the [Logout] button at the top-right of the page, then close your web
browser.
11.3 Resetting the keypad to factory
defaults
If your JCU-3 keypad is operating abnormally, or you have inadvertently
saved unwanted changes from the JCU Configuration pages, you can reset
the keypad to the factory defaults.
Note:
If you reset the JCU-3 keypad to the factory defaults, any previous camera
pairing information will be lost.
1. Complete steps 1 to 4 in the following section:
2. In the left-hand menu, click [FIRMWARE].
The Firmware page is displayed.
3. At the bottom of the [FIRMWARE] page, click the [Factory] button.
The keypad backlights turn off while the factory restore process is in
progress; a message box – "Factory Defaults have been restored" – is
displayed within a few seconds once the process has completed, and the
keypad backlights turn on.
4. Click [OK] to acknowledge the Factory Defaults restored message.
5. Click the [Logout] button at the top-right of the page, then close your
web browser.
p.39 — Pairing the keypad