Jcu-3 Controls: Notes; Setting The Keypad Orientation - Teledyne JCU-3 Installation & Operation Instructions

Item Description
11 [NEXT PAYLOAD]
• Short-press to switch to the next payload on the camera
(applicable only to cameras with multiple payloads; for
example: thermal and visible)
12 [POWER]
• Short-press to cycle through keypad backlight brightness
settings.
• Long-press to put the camera into standby mode (parked
and stowed); press any other button to wake the camera.
• Double-press to switch to the next available camera in the
network.
JCU–3 controls: notes
Note:
The listed button actions are the default actions for a JCU-3 keypad
controlling an M100/M200 Series thermal camera.
Note:
You can change the default actions of certain buttons and controls for
M100/M200 Series cameras (including the user programmable buttons)
using the camera's web interface.

Setting the keypad orientation

If you choose to replace the fitted portrait-oriented keypad mat with the
landscape-oriented keypad mat, you must also change the "Orientation"
setting using the JCU-3 keypad web interface.
Note:
Changing the orientation setting requires a PC, laptop – or other
IP-network compatible device that supports a web browser – to be
connected to the same network as the keypad.
You complete the process using web pages served by the JCU-3 keypad.
38
1. Make sure that your PC/laptop is configured to detect UPnP devices.
For example, in Windows 7, 8, and 10, within the Network and Sharing
Center, you'll need to select the option to Turn on network discovery.
2. The keypad is automatically added to the list of devices on your
PC/laptop, and is named according to the keypad part number, and serial
number (for example: A80510 0123456).
In Windows XP, the keypad is listed in Windows Explorer under "My
Network Places"; in later versions of Windows, the keypad is listed in
Windows Explorer under "Network".
3. For Windows computers, double-click the keypad item to open the
keypad's web page. You can also right-click the keypad item and select
Properties, to show more information about the keypad, including its
IP address.
The login screen with a picture of the JCU-3 is displayed.
4. Enter user for Username and user for Password, then click Login.
The JCU configuration page is displayed.
5. Click JCU HARDWARE.
The hardware configuration page is displayed.