Avaya 1050 Installation Manual page 17

b. If you are using a single Avaya Video MicPod 1000 for audio, insert the end of the
cable from the Avaya Video MicPod 1000 into the microphone port marked with the
microphone symbol
upright position with the stand, Avaya recommends you route this cable through the
strain relief guide on the stand. If the Avaya Video MicPod 1000 is installed in an
area where the cord could be pulled or tripped upon, refer to "Attaching the Avaya
Video MicPod 1000 Strain Relief Clip" on page 22.
Warning:
injury as well as permanent damage to the Avaya Video MicPod 1000 cord
connector and the connector in the codec. Avaya recommends that you use the
cable strain relief clip included in the Avaya Video MicPod 1000 product box as
described in "Attaching the Avaya Video MicPod 1000 Strain Relief Clip" on
page 22.
If you are using dual Avaya Video MicPod 1000s for audio, refer to "Configuring
Dual Avaya Video MicPod 1000s" on page 21 for a description of supported
configuration options.
7. Insert the cord from the power adapter into the power outlet marked
the back of the codec (near the base). Insert one end of the power cord into the power
adapter and the opposite end into a power outlet on the wall.
The Avaya system starts and illuminates a blue LED on the front of the codec. See
"Status Icons" on page 26 for more information about the state of the system as it boots
or as conditions change.
The camera initializes the first time it is connected to a codec; this process takes
approximately 90 seconds.
Warning: Do not disturb or disconnect the devices during this time as you may
damage the system.
17
on the back of the codec. If you are using the codec in the
Tripping on the Avaya Video MicPod 1000 cord can cause personal
Avaya 1050 Installation Guide
on