Battery Charging And Care; Charging The Battery - CareCo Daytona XLR Usage And Maintenance Instructions

Table of Contents

Advertisement

Daytona XLR Mobility Scooter - MS03038
14

5. Battery charging and care

5.1
Charging the batteries
Follow the procedure below step by step:
1.
Turn the power switch to off
2.
Connect the charger's power cord into the power outlet.
3.
Open the charging socket cap on the scooter's tiller. Then connect the charger's round plug to the charging
socket.
4.
Turn on the switch on the charger.
5.
Both the charger's red and orange leds will be lit when beginning to charge. The charging duration is about 8
hours. To ensure optimum performance a 12-14 hour charge is recommended. However, we do not recommend a
charging of more than 24 consecutive hours.
6.
Both the charger's LEDs will be lit during the charging process. The orange LED will turn green after 1-4 hours but
continue to charge for between 8 – 14 hours.
7.
Turn off the charger; disconnect the power cord and the round plug from charger socket on the scooter.
Warning
The fan inside the charger will be activated accordingly when you turn on the charger. If the fan does not work
when connected to the charger or the green light is not showing, DO NOT use this charger. The charger may
overheat and cause a fire as a result.
There is a red LED present on the charger to illustrate operation. If this LED does not illuminate the charger is
defective - please contact CareCo Customer Service on 0845 611 8022 or email: cs@careco.co.uk
Attention
While gripping or folding the handle bar, beware of trapping fingers or hands in the handle area.
When returning the battery pack to the battery pack cavity of the shroud, again, beware of trapping fingers or
hands.
A flap at the end of battery pack can be opened to place your bag (not over 3 kg).
Warning
1.
Keep away from flammable objects while charging due to danger of fire or explosion of batteries.
2.
Do not smoke while charging as the batteries may release hydrogen gas. Always charge your batteries in a
well-ventilated area.
3.
Never connect or disconnect the plug or cord with wet hands while charging. Do not connect or disconnect the
plug or cord when they are wet as this may cause an electric shock.
NOTE:
The immovable function will be activated when your scooter is in charging status; your scooter will not move.
www.careco.co.uk
CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ms03038

Table of Contents