Prepare your chipper-shredder
for storage at the end
of the season or if the unit will not be used for 30 days
WITH FUEL IN THE FUEL TANK INSIDE
REACH AN OPEN FLAME OR SPARK, OR
SUCH AS HOT WATER
SPACE HEATERS, FURNACES, CLOTHES
DRYERS, STOVES, ELECTRIC
NOTE: A yearly check-up by your local Sears Service
Center is a good way to make certain your chipper-
shredder will provide maximum
• Clean the chipper-shredder
• Wipe unit with an oiled rag to prevent rust (use a
light oil or silicone).
IT IS IMPORTANT
PARTS SUCH AS CARBURETOR,
OR TANK DURING
STORAGE. ALSO, EXPERIENCE
FUELS (CALLED GASOHOL
ATTRACT MOISTURE WHICH LEADS TO SEPARA-
TION AND FORMATION OF ACIDS DURING STOR-
AGE. ACIDIC GAS CAN DAMAGE THE FUEL SYS-
TEM OF AN ENGINE WHILE IN STORAGE.
• Drain the fuel tank.
• Start the engine and let it run until the fuel lines and
carburetor are empty.
• Never use engine or carburetor cleaner products in
the fuel tank or permanent damage may occur.
• Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable
minimizing the formation of fuel gum deposits during
storage. Add stabilizer to gasoline in fuel tank or stor-
Always follow the mix ratio found on
Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to reach
the carburetor. Do not drain the gas tank and carbure-
tor if using fuel stabilizer.
Drain all the oil from the crankcase (this should be
done after the engine has been operated and is still
warm) and refill the crankcase with fresh oil.
If you have drained the fuel tank, protect the inside
of the engine as follows. Remove spark plug, pour
1/2 ounce (approximately
spoon) of engine oil into cylinder and crank slowly
to distribute oi!. Replace spark plug.
Do not store gasoline from one season to another.
Replace your gasoline can if your can starts to rust.
Rust and/or dirt in your gasoline will cause problems.
• Store unit in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: If storing in an unventilated
or metal storage
shed, be certain to rustproof the equipment by coating
with a light oil or silicone.
SERVICE & ADJUSTMENT
WARNING: ALWAYS STOP ENGINE AND
SPARK PLUG WIRE AND
MENTS OR REPAIRS.
REMOVING THE FLAIL SCREEN
If the discharge area becomes
clogged, remove the
flail screen and clean area as fo!lows.
• Stop the engine, make certain the chipper-shredder
has come to a complete stop and disconnect spark
plug wire from the spark plug before unclogging the
Loosen the two hand knobs on each side of the
chute deflector. Lift the chute deflector up, and tie it
out of the way.
• Remove two hairpin clips from the clevis pins which
pins. Lift the flail screen from inside the housing.
See figure 18.
water. Reinstall the screen.
NOTE: Be certain to reassemble the flail screen with
the curved side down as shown in figure 18.