Table of Contents
Advertisement
Figure 7
1. Cut-off bar
2. Bolt (1/4 x 1-3/4 inches)
4. Insert a 1.5 mm (0.060 inch) feeler gauge between the
top of the reel and the bottom of the cut-off bar to
check clearance
(Figure
Note: Make sure the bar and reel are equal distance
apart across the full length of the reel. The cut-off bar
must not contact the reel during operation.
Figure 8
1. Feeler gauge
5. Tighten the bolts and locknuts
6. Do not install the grass shield at this time.
3. Locknut (1/4 inch)
8).
(Figure
7).
6
Installing the New
Grass Deflector
(Front Cutting Units Only)
No Parts Required
Procedure
g012219
1. Remove the 2 center deflectors and the deflector from
each end of the shield, leaving only the 2 shown in
Figure
9.
1. Do not remove these deflectors.
2. Mount the new deflector to the left end of the shield
with 2 screws (10-24 x 1/2 inch) and nuts (10-24) as
shown in
Figure
g012220
1. New deflector
2. Screw (10-24 x 1/2 inch)
6
Figure 9
10.
Figure 10
3. Nut (10-24)
g012221
g012277
Advertisement
Table of Contents
