Advertisement
Quick Links
Operator Golf Ball Guard
Reelmaster
Traction Unit
Model No. 03614
This product contains a chemical or chemicals known to the State of California
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Guard assembly
Left mounting bracket
Right mounting bracket
Strap
Carriage bolt—3/8 x 4-1/2 inch (Reelmaster
3555/3575 Series traction unit only)
Carriage bolt—3/8 x 3-1/2 inch (all except
Reelmaster 3555/3575 Series traction unit)
Flange nut
Carriage screw (3/8 x 7/8 inch)
Shoulder bolt
Spacer
Preparing the Machine
Park the machine on a level surface, engage the
parking brake, shut off the engine, and remove the
key from the key switch
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3100/3500/5010 or Groundsmaster
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
(Figure
1).
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
Prepare the machine.
1
1
1
4
4
Install the guard.
4
14
8
2
2
Form No. 3411-852 Rev B
®
3500/4300 Series
Installation Instructions
Use
Figure 1
Original Instructions (EN)
All Rights Reserved *3411-852* B
Printed in the USA
g037695
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Toro 03614
Summary of Contents for Toro 03614
- Page 1 Reelmaster ® 3100/3500/5010 or Groundsmaster ® 3500/4300 Series Traction Unit Model No. 03614 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm.
-
Page 2: Installing The Guard
Installing the Guard Installing the Guard on a Reelmaster 3100/3500 Series or Groundsmaster 3500 Series Traction Unit 1. Loosely mount the brackets to the roll bar as shown in Figure g198197 Figure 3 1. Guard wing—initial 2. Guard wing—final position position 3. - Page 3 Installing the Guard on a Reelmaster 3555/3575 Series Traction Unit 1. Loosely mount the brackets to the roll bar as shown in Figure g198626 Figure 5 1. Short carriage screw (8) 3. Flange nut (8) 2. Guard assembly 5. Tighten the flange nuts to secure the brackets to the roll bar (Figure 6.
- Page 4 3. Use the 2 shoulder bolts, 2 spacers, and 2 5. Tighten the flange nuts to secure the brackets to flange nuts to attach each latch-arm link to each the roll bar (Figure guard wing (Figure 6. Check the clearance between the hood of the machine and the guard assembly.
- Page 5 g198197 Figure 11 1. Guard wing—initial 2. Guard wing—final position position 3. Use the 2 shoulder bolts, 2 spacers, and 2 g211695 flange nuts to attach each latch-arm link to each Figure 13 guard wing (Figure 12). 1. Short carriage screw (8) 3.
- Page 6 Maintenance Operation Using the Guard Checking the Mesh You can retract the guard wings to allow easy access Service Interval: Before each use or daily—Check to the operator platform. Use the latches to secure the the mesh for damage. sides in the open or closed position (Figure 14).
- Page 7 Notes:...
Need help?
Do you have a question about the 03614 and is the answer not in the manual?
Questions and answers