Table of Contents
Advertisement
3. Install the grass shield and remaining deflectors.
7
Removing the Support Tube
Parts needed for this procedure:
2
Flange locknut (3/8 inch)
Procedure
1. Unthread the 2 flange-head bolts securing the support
tube to the cutting unit side plates
the support tube.
2. Secure the flange-head bolts to the cutting unit side
plates with the 2 flange locknuts (3/8 inch) included
(Figure
11).
1. Support tube
2. Side plate
8
Assembling the Rear Grass
Basket
No Parts Required
Procedure
1. Remove the washers and nuts shipped on the strap
bolts
(Figure
12).
(Figure
11). Remove
Figure 11
3. Flange-head bolt
4. Flange locknut (3/8 inch)
2. Using the cable ties on straps as handles, stretch each
strap until it can be secured to top of basket with 2
washers and a locknut
on each side of the basket top.
Note: Cut off the cable ties after the straps are
installed.
Note: To ease the installation of straps, place an 8
inch x 4 inch wood block
to raise and support the top of the basket.
1. Strap
2. Strap bolt
Note: If the straps become stretched and do not hold
top of basket open, use the guide holes
the rear of the basket to locate and drill new mounting
holes for the strap bolts.
g012222
1. Guide hole (2)
7
(Figure
12). Position a washer
(Figure
12) inside the basket
Figure 12
3. Cable tie
4. Wood block
(Figure
Figure 13
g012223
13) in
g012224
Advertisement
Table of Contents
