Chapter 3. Uefi Events; Uefi Events Organized By Severity - Lenovo ThinkSystem SE350 V2 Manual

Chapter 3. UEFI events

UEFI error messages can be generated when the server starts up (POST) or while the server is running. UEFI
error messages are logged in the Lenovo XClarity Controller event log in the server.
For each event code, the following fields are displayed:
Event identifier
An identifier that uniquely identifies an event.
Event description
The logged message string that appears for an event.
Explanation
Provides additional information to explain why the event occurred.
Severity
An indication of the level of concern for the condition. The severity is abbreviated in the event log to the
first character. The following severities can be displayed:
• Informational. The event was recorded for audit purposes, usually a user action or a change of states
that is normal behavior.
• Warning. The event is not as severe as an error, but if possible, the condition should be corrected
before it becomes an error. It might also be a condition that requires additional monitoring or
maintenance.
• Error. The event is a failure or critical condition that impairs service or an expected function.
User Action
Indicates what actions you should perform to solve the event. Perform the steps listed in this section in
the order shown until the problem is solved. If you cannot solve the problem after performing all steps,
contact Lenovo Support.

UEFI events organized by severity

The following table lists all UEFI events, organized by severity (Information, Error, and Warning).
Table 3. Events organized by severity
Message String
Event ID
FQXSFDD0008I Self-Encrypting Drive (SED) Error: recovered from failure to get key.
FQXSFDD0009I Self-Encrypting Drive (SED) Error: recovered from failure to access
drive [arg1].
FQXSFDD0010I Self-Encrypting Drive (SED) Error: recovered from failure to unlock
drive [arg1].
FQXSFDD0011I Self-Encrypting Drive (SED) Error: recovered from failure to set
password to drive [arg1].
FQXSFDD0012I SATA Hard Drive Error: [arg1] was recovered.
An intra-board UPI has been disabled on the link between processor
FQXSFIO0005I
[arg1] port [arg2] and processor [arg3]port [arg4] because of UPI
topology downgrade.
© Copyright Lenovo 2023
Severity
Informational
Informational
Informational
Informational
Informational
Informational
137