Cruise Control - Jeep AVENGER 2023 Owner's Handbook Manual

ADJUSTING THE SPEED SETTING
To change the speed setting using the
vehicle's current speed:
for steps of +/- 1 km/h (1 mph),
make successive short presses
upwards/downwards on (2) to
increase/decrease
for steps of +/- 5 km/h (5 mph), press
and hold upwards/downwards on (2) to
increase/ decrease
When the function is activated, it is
possible to modify the cruise speed
setting based on the speed suggested by
the Traffic Sign Recognition function, as
shown on the instrument panel:
When passing the sign:
press (1) OK to save the
suggested speed. This value is then
immediately shown as the new
speed setting on the instrument
panel
After passing the sign:
Press (1) OK. The message "OK?"
fig. 181 is displayed to confirm the
request to save
Press (1) OK again to save the
suggested speed. The new speed
setting value is displayed on the
instrument panel
140
181
TEMPORARILY EXCEEDING THE
SPEED SETTING
fully depress the accelerator pedal.
The speed limiter is temporarily
deactivated and the displayed speed
setting flashes
release the accelerator pedal to return
to below the speed setting
When the vehicle speed returns to the
speed setting level, the speed limiter
operates again: the speed setting display
becomes fixed again.
OFF
Press (4): the speed limiter information
display disappears.
MALFUNCTION
In the event of a malfunction, dashes
are displayed flashing and then fixed
(orange) instead of the speed setting.
Have it checked by a Jeep Dealership.
WARNING
178) While driving with the device active,
never move the gear lever to neutral or the
PRND command to N.
179) In case of a malfunction or failure of
the device, contact a Jeep Dealership.
180) On a steep descent or in the event of
sharp acceleration, the speed limiter will
not be able to prevent the vehicle from
exceeding the speed setting. If necessary,
JJ000611
apply the brakes to control your vehicle's
speed.

CRUISE CONTROL

(where provided)
181) 182)
WARNING For more information, refer to
the "Advanced Driver Assistance Systems
(ADAS) recommendations" chapter in
this section.
This system automatically maintains the
vehicle's speed at the value programmed
by the driver (speed setting), without the
use of the accelerator pedal.
Cruise control is switched on manually.
It requires a minimum vehicle speed of
40 km/h (25 mph).
NOTE Cruise control remains active after
changing gear on engines fitted with
Stop-Start.
NOTE Switching off the ignition cancels
any speed setting.