Stacker Plate Replacement - Fujitsu ULTIMA90 Maintenance Manual

3. Raise the stacker table, then hold both ends of the cut sheet feeder and pull it off.
Installation
1. Turn off the printer power.
2. Raise the stacker plate, then engage the U-grooves on both ends of the cut sheet feeder with the mounting pins
on the printer and lower the cut sheet feeder carefully.
(Push in the cut sheet feeder while aligning label A on the feeder with label A on the right side of the printer.)
3. Lower the cut sheet feeder like turning it using the mounting pins as fulcrums.
4. Connect the cut sheet feeder cable connector to the connector on the rear left of the printer.
5. Insert the connector with the arrow side facing upward.
Note. When attaching the cut sheet feeder to the rear of the printer, replacing the stacker with large stacker is necessary.
Mounting pin
Cable

(3) Stacker Plate replacement

Removal
1. Raise the stacker plate in the direction indicated by an arrow.
Connecto r
Figure 4.9 Rear Cut Sheet Feeder replacement
Stacker plate
Mounting pin 1
Mounting pin 2
39