Fujitsu ULTIMA90 Maintenance Manual page 6

Centronics parallel Connector
b. Upper cover
The bottom cover and the upper cover are fixed with a back screw.
b. Front cover
The front cover is opened to replace the ribbon cartridge. There
is an Interlock SW for safety.
c. Soundproof cover
Soundproof cover is opened when the continuous form is set.
How to handle refer to the Quick Start Guide or User's Manual.
d. Rear stacker
The rear stacker holds printed cut sheets.
The optional Large Stacker is necessary to use cut sheets exceeding 297 mm in length
e. Control panel
[LED type]
The control panel consists of an LSI, 10 push-button switches, 1 dial, 13 LEDs, and a buzzer.
The switches are used for operations such as loading and feeding paper and controlling printing pressure.
Some switches are also used in setup mode. The LEDs indicate printer basic statuses and paper feed path
conditions. The buzzer sounds to indicate certain operating and printer statuses.
[LCD type]
The control panel consists of an LSI, 11 push-button switches, 1 LCD, 8 LEDs, and a buzzer.
The switches are used for operations such as loading and feeding paper and controlling printing pressure.
Some switches are also used in setup mode. The LEDs indicate printer basic statuses and paper feed path
conditions. LCD displays the state of the printer. The buzzer sounds to indicate certain operating and printer
statuses.
Centronics parallel Connector
Clip USB Connector
Figure 1.4 Interface type of DL7600
[LED type]
6
RS232c Serial Connector
LAN Connector Option
The ferrite core that
Comes with the LAN
Card must be attached.