Fujitsu ULTIMA90 Maintenance Manual page 27

Dot matrix printer
Table of Contents

Advertisement

[LED type]
The PAPER OUT indicator is lighted.
The buzzer sounds, the PAPER OUT indicator lights up, and the printer is placed offline when operation is
required.
[LCD type]
The error message is displayed with LCD.
The buzzer sounds, display the error name by the LCD displa y , and the printer is placed offline when operation
is required.
Error name
LOAD JAM
Jam occurred at the time of load.
EJECT JAM
Jam occurred at the time of eject.
LOAD ERROR
Skew when the cut sheet was load.
HOPPER EMPTY
Paper of the CSF disappeared.
PAPER END
The printer has run out of continuous forms.
UNLOAD ERROR
The retreat operation of continuous forms was
not able to be completed.
PAPER
The retreat operation of continuous forms was
SELECT
not able to be completed.
ERR
REMOVE PAPER
The cut sheet remains being put on the paper
table.
COVER OPEN
The front cover is open.
Notes:
1. The printer cannot be set online until these errors are cleared.
2. The paper end is ignored if setup item PPR-OUT: IGNORE is set.
(3) Fatal alarms
The power shut down by itself.
The printer cannot display the alarm if it detects the following alarms that turn off printer power. Disconnect
components or connectors for related alarms, then check the cause of the alarm.
Error name
+40 V over voltage alarm
[LED type]
The PAPER OUT lamp blinks with other lamps.
For a circuit malfunction detected in the printer:
• The printer stops printing immediately.
• The ONLINE indicator turns off.
• All buttons of the control panel are invalid.
Table 3.2 Operational errors
Cause of the error
Table 3.3 Alarms that turn power off
The power supply is faulty.( The power supply is a high voltage.)
27
Recovery
Remove a paper from a printer.
Remove a paper from a printer.
Load again straight.
Supply forms and load them into the
printer.
Supply forms and load them into the
printer.
The "LOAD" switch is pushed and retreat
operation is performed again.
The "LOAD" switch is pushed and retreat
operation is performed again.
The cut sheet is extracted.
The front cover is close.
Cause of the error

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ultima90 +Impact4550 proDl7600

Table of Contents