Table of Contents
Advertisement
E R R O R C O D E S
When power is applied, the unit will automatically enter a "Reset/Test" mode. This mode brings all the
internal motors to a home position. If there is an internal problem with one or more of the motors an
error code will flash in the display in the form of "XXer" were as XX will represent a function number.
For example, when the display shows "0Er" it means there is some type of error with the Pan motor. If
there are multiple errors during the start-up process they will all flash in the display. For example: if the
fixtures has errors on Channel 1, 2, and 5 all at the same time, you will see the error message "01Er",
"02Er", and "05Er" flash repeated 5 times.
If an error does occur during the initial start-up procedure the fixture will self-generate a second reset
signal and try to realign all the motors and correct the errors. If the error persists after a second
attempt a third attempt will be made. If after a third attempt all the errors have not been corrected
the fixture will make the following determinations:
•
3 or More Errors: The fixture cannot function properly with three or more errors therefore the
fixture will place itself in a stand-by mode until subsequent repairs can be made.
•
Less Than 3 Errors: The fixture has less than 3 errors; therefore, most other functions will work
properly. The fixture will attempt to operate normally until the errors can be correct by a technician.
The errors in question will remain flashing in the display as a reminder of internal errors.
ERROR CODES
Pan
Tilt
Cyan
Megenta
Yellow
CTO
CTB
Color Wheel
Gobol
Gobol_ROT
Gobo2
Gobo2_ROT
Fixed_Gobo
Focus
Zoom
Prism1
Prism_Rot1
Prism2
Prism_Rot2
Frost1
Frost2
Iris
Animation
AnimationRot
Blade_Rot
LED Temp Error
Head Temp Error
Base Temp Error
3UHeadFan1 Error
3UHeadFan2 Error
3UHeadFan3 Error
3UHeadFan4 Error
3UHeadFan5 Error
5UHeadFan1 Error
8UHeadFan1 Error
11UHeadFan1 Error
11UHeadFan2 Error
11UHeadFan5 Error
11UHeadFan6 Error
Base Fan1 Error
Base Fan2 Error
Base HD Warning.
Base HD Higher.
Head HD Warning.
Head HD Higher.
Base HD Error.
Head HD Error.
Error Codes subject to change without notice
Movement is not located in the default position after the reset. This
message will appear after a fixture reset if the magnetic-indexing circuit
malfunctions (sensor failed, or magnet is missing) or there is a motor
failure (defective motor or a defective motor IC drive on the main PCB).
DESCRIPTION
45
Advertisement
Table of Contents
