Table of Contents
Advertisement
INSTALLATION GUIDELINES
POWER AND DATA CABLES
ENSURE ALL CONNECTIONS AND ENDCAPS ARE PROPERLY SEALED WITH
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT
WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
TO MAINTAIN THE IP65 RATING INTEGRITY OF THE FIXTURE AND PREVENT WATER
FROM ENTERING THE FIXTURE, SEAL ALL UNUSED CONNECTION RUBBER CAPS.
BATTERY REPLACEMENT
Installing the battery incorrectly, in the wrong orientation, where the Plus (+)
is inside and Negative (-) is outside, will lead to internal electronics and battery
damage. A qualified electrician should be used for all electrical connections and/
or installations.
1. Loosen the screw cap for the battery compartment.
2. Remove old battery and replace (inside "-", and outside "+").
NOTE: Replace the battery only with an Li-ion battery (IRC14500/700mAh), which can
be ordered from the Elation Parts Website
product/view/id/18373/s/60420050026/category/2/
3. Replace and tighten screw cap for the battery compartment.
https://parts.elationlighting.com/catalog/
23
Advertisement
Table of Contents
