Out.cnf (Output Configuration) - Omega DP461-S User Manual

9
Meter Function Menus

9.2.16 OUT.CNF (Output Configuration)

Output configuration is used to select:
• whether or not to send data to the optional analog output board [OUT.1]
• the analog output signal of 0-10 V dc or 4-20 mA DC [OUT.2]
• whether or not to send data to the optional BCD output board [OUT.3]
• to send peak value via the optional BCD output board [OUT.4]
• to select type of BCD output [OUT.5]
• enable or disable the flashing display [OUT.6]
MENU
BUTTON
MAIN MENU
"OUT.CNF":
* The 'MIN' button allows you to sequence through OUT.1, OUT.2, OUT.3,
OUT.4, OUT.5, and OUT.6.
The 'MAX' button allows you to select the "0", "1", "2", "3", "4" or "5" state for
each "OUT" condition.
The 'MENU' button stores the selected values for each "OUT" condition
changed and advances the meter to the next configuration ("OT.SC.OF").
Every underlined item is the factory preset value.
9-24
MIN/MAX/MENU *
BUTTON
SUB MENU
"OUT.1=0"
"OUT.1=1"
"OUT.2=0"
"OUT.2=1"
"OUT.3=0"
"OUT.3=1"
"OUT.4=0"
"OUT.4=1"
"OUT.5=0"
"OUT.5=1"
"OUT.6=0"
"OUT.6=1"
"OUT.6=2"
"OUT.6=3"
"OUT.6=4"
"OUT.6=5"
DESCRIPTION
OUTPUT CONFIGURATION
Data on the Analog Output Board:
Disabled
Enabled
Analog Output Mode:
0-1 V, 0-5 V, 1-5 V, 0-10 V
0-20 mA or 4-20 mA
Data out on Parallel BCD Board:
Disabled
Enabled
Type of data out on BCD Board:
Display
Peak
BCD Output:
Used for standard parallel printers.
Used for Specialty printers.
Type of Display Flashing:
Disabled - display flashing.
SP1 active - display flashing.
SP2 active - display flashing.
SP3 active - display flashing.
SP4 active - display flashing.
any SP active - display flashing.