Table of Contents
Advertisement
WARNING: Do not "turn-on" the ac power and input signals until all
connections are connected to the meter.
11. Set P1, the AC power connector, aside and connect or reconnect all
other connectors to the back of the meter using Figures 4-3 and 4-4 in
Section 4.2 as guides.
Connect P1 last.
NOTE: The P1 connector is "keyed"; it is shaped in such a way that it fits
Note
only the J1 male pins.
12. Replace the rear protective cover and secure it with the cover mounting
screw.
Your meter is now ready for operation and you can turn-on the power.
The meter display should light, and pass through "RESET 2" to run or
display mode. If the meter flashes an overscale or overload message, press
the 'MENU' button to advance to the configuration mode. Do not be
concerned about overloads (the +S input can stand 120 V continuously and
current inputs can handle ten times rated current).
5
Setup
5-13
Advertisement
Table of Contents
