Setting A Privacy Mask - Sony IPELA SNC-RZ50N User Manual

Viewer
A live image of the camera is displayed. You can specify
the position of the privacy mask in this area.
If you click on the image, the camera moves so that the
clicked point goes to the center of the image.
Panorama image area
The panorama image created with the supplied SNC
panorama creator is displayed.
The positions of the registered privacy masks are shown
with numbers in this area.
If you click on the panorama image, the camera moves
to the clicked point.
Note
The default image is shown when no panorama image
has been created.
PTZ Controller (control panel)
Allows you to pan, tilt and zoom the camera.
Pan/tilt control
Click the arrow button of the direction in which you
want to move the camera. Keep it pressed to move the
camera continuously.
Zoom control
Click to zoom out, and click
zoom in. Zooming continues while the button remains
pressed.
The current zoom status is shown on the zoom bar. The
left end is the WIDE end, and the right end is the TELE
end.
Click to move the zoom to the WIDE end.
Click to move the zoom to the TELE end.
Privacy mask setting section (No.1 to No.8)
Allows you to set, call or delete the privacy mask.
You can set up to eight privacy masks and the mask
color.
Set: Register the area specified on the viewer as a
privacy mask area.
Click Set and the portion of the viewer image is
masked with the privacy mask. The color of the
privacy mask is that selected with the Color drop-
down list.
Notes
• When using the privacy mask function, set Stabilizer
to Off. (page 38)
• If the mask area is close to the bottom end of the
image, the background at the bottom may be seen.
Call: Click to face the camera to the privacy mask
position.
Tip
The privacy mask positions are shown with numbers in
the panorama image area.
Clear: Click to delete the privacy mask.
Color
Specify the color of privacy masks. The color is
common to every privacy mask.
If you select Transparent, a background is seen
through.
The selectable colors are as follows:
Black, White, Gray, Red, Green, Blue, Cyan, Yellow,
Magenta
All clear
Click to delete all the privacy masks simultaneously.

Setting a privacy mask

To set a privacy mask in a favorite position, operate as
follows:
1
Move the camera to the position you want to set a
privacy mask using the control panel in the Main
tab.
to
2
Click the point where you want to set the privacy
mask on the viewer. The clicked point goes to the
center of the image.
3
Specify the privacy mask area by dragging the
mouse on the viewer.
The privacy mask area is a rectangle that is
symmetrical with respect to the center of the
viewer.
4
Select the color of the mask from the Color drop-
down list.
Note
The color is common to every privacy mask. The
color last selected is applied.
5
Select the desired privacy mask number in the
privacy mask setting section and click Set of the
corresponding number.
The mask is displayed on the viewer.
Note
The mask cannot be set on the viewer by clicking Set, if
the camera is tilted beyond +70°.
Using the SNC privacy masking tool — Masking a Camera Image
107