Position
Available to call out the privacy masks, delete them one
by one or delete all at one time.
After completing the configuration, register by clicking
OK.
Call: Clicks the button to turn the camera facing to the
position where the privacy mask is set.
Clear: Click the button to delete the privacy mask set.
All clear: Click the button to delete all privacy mask.
Color
Specify the color of privacy masks. This setting is
common to every privacy mask.
The colors used are as follows:
Black, Gray1, Gray2, Gray3, Gray4, Gray5, Gray6,
White, Red, Green, Blue, Cyan, Yellow, Magenta
Setting a privacy mask
Operate according to the following procedure to set a
privacy mask in the position of your choice:
1
Face the camera to the position where you want to
set a privacy mask using the control button on the
preview screen.
2
Specify the privacy mask area by dragging the
mouse on the preview screen.
The privacy mask area is formed as a rectangle that
is symmetrical to the center of the preview screen.
3
Select the number to register from the Position
drop-down list.
4
Select the color of the mask from the Color drop-
down list.
5
Click OK.
The mask is displayed on the preview screen.
Note
• The mask cannot be set on the viewer by clicking OK
if the camera is tilted beyond +65°.
• If you change the direction of the camera, the mask
may not cover the object properly. Ensure the Privacy
masking area is sized sufficiently beforehand.
• The color is common to every privacy mask. The color
selected last is applied.
Privacy mask setting range
The setting range of the privacy mask is limited as
follows:
Pan angle:
SNC-ER520/ER521/ER550/ER580: No limit
SNC-EP520/EP521/EP550/EP580: 340°
Tilt angle:
Note
The privacy mask area is a rectangle that is specified
with respect to the center of the camera image. The
privacy mask may not be set in areas close to the end of
pan/tilt operation.
OK/Cancel
See "Buttons common to every menu" on page 35.
Setting the Camera Image and Audio — Camera Menu
15°
65°
47