Zooming - Sony IPELA SNC-RZ30N User Manual

Observe the monitor image and click the arrow button
indicating the direction in which you want to move the
camera. The camera moves and the monitor image
follows.
Hold down the arrow button to move the direction of the
camera continuously.
Click to return the camera to the factory-preset
default position.
Notes
• If the Exclusive control mode menu on the System
setting page is set to On (see page 17), the remaining
operation time is displayed instead of
• You can change the operation mode of the panning and
tilting using the 8-direction arrow buttons from the
Camera control mode setting section on the Camera
setting page (see page 22). When you have changed
the operation mode, click Control on the menu
section to update the operation mode setting on the
image control section.
Panning and tilting using the tablet
When you click PT MODE, the 8-direction arrow
buttons change to a tablet. The tablet represents the
monitor image.
A click on the tablet moves the direction of the camera
so that the clicked position goes to the center of the
monitor image.
If you want to change the direction of the camera further,
click on the tablet and drag in the direction in which you
want to move the camera. The direction of the camera
moves as you drag. Hold down the button to move the
direction of the camera continuously.
Notes
• The tablet represents the whole monitor image even
when you have trimmed the monitor image using the
Area setting menu on the Camera setting page (see
page 20).
• If the Exclusive control mode menu on the System
setting page is set to On (see page 17), the remaining
operation time is displayed on the lower right corner
of the tablet.

Zooming

CIick to zoom in.
Click to zoom out.
Note
You can change the operation mode of the zooming
.
using the TELE/WIDE buttons from the Camera control
mode setting section on the Camera setting page (see
page 22). When you have changed the operation mode,
click Control on the menu section to update the
operation mode setting on the image control section.
When the Zoom mode menu on the Camera setting page
is set to Optical only, clicking this button operates the
electronic ×2 zoom.
The button name changes to DZOOM x 1.
When the Zoom mode menu on the Camera setting page
is set to Optical only, this button is displayed while the
electronic ×2 zoom is operating. Clicking this button
cancels the electronic ×2 zoom.
The button name changes to DZOOM x 2.
About the zoom range
When the Zoom mode menu on the Camera setting page
is set to Full (see page 20), you can operate high-
magnification zoom, optical zoom of × 25 and electronic
zoom of × 12, giving × 300 in total. The electronic zoom
will operate after the optical zoom.
When the Zoom mode menu is set to Optical only, only
optical zoom of × 25 can operate. In this case, you can
use an electronic zoom of × 2 by clicking the DZOOM
x 2 button. To cancel the electronic zoom, click
DZOOM x 1.
Note
When you have changed the Zoom mode menu on the
Camera setting page, click the Control button on the
menu section to update the zoom mode setting on the
image control section.
Operating the Camera from the Image Control Section
11