Among the subjects dealt with in this Instruction Manual are: Therefore please read this Instruction Manual carefully! • Proper application • Physical limitations of the product • Risks with improper use S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
The forks will lift 190 mm before the telescopic mast begins to extend. Applies to: 2050 - 3300 ELFS 2020 - 3270 ELFS When handling closed pallets... - Use the straddle Logiflex! S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
• Chains and chain bolts must not be damaged. Chains that have become permanently stretched (max. 2 % of original length) must be scrapped. Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com S612...
• The fork bracket loading is dependent on the lifting height and can be read on the load dia gram. • Load limitation at significant heights is incorporated to give greater stability of the Logiflex and operator safety. S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
The product has an emergency stop. When activating the emer- gency stop, the main current supply is switched off. The movement of the forks stops immediately when activating the emergency stop. Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com S612...
Make sure that the connections are in order. Check connections regularly for damage at insulating caps or bad connections at plugs, etc. Verdigris must be removed from cable plugs. Keep all screw/nut connections tight. S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
Adjustable carriage: the forks are to be kept clear of the floor The nuts (pos. 18) are to be adjusted (nut M12, key width 19 mm). S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
4. Pump the forks to its top position, and when lowering it has to slide to the bottom. If this is not the case, loosen screw A, make approx. 0.5 turn counter-clockwise and repeat point 4. Mast roll C Profil (Mast) Fork Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com S612...
The screen is to be washed with slightly warm water added a neutral cleaning material, and afterwards washed with clean water. Use a soft sponge, a woollen cloth or a wash leather. Never use sharp objects or solvent cleaners when cleaning. S612 Tel. +45 76 88 16 00 . info@logitrans.com . www.logitrans.com...
Such affected parts shall be sent to your Logitrans dealer carriage paid within the warranty period in force at the time in question, together with a copy of the documentation for the service performed (B0284 - see the back page).
8.0 Fault location key When the Logiflex is used every day, adjustments and the replacement of worn parts might be necessary. If a fault appears during daily operation of the LOGIFLEX, first check: • Oil supply • Electricity supply • Condition of leads and fuses If faults cannot be traced to these sources, contact your dealer, but...
Page 17
Cause Mending See point Oil deficiency 6.1/6.2 See seperate Battery discharged manual See point Fuse blown 10A or 100A See point Cables defective See point Max. load exceeded See point Air in hydraulic system Contact Pressure relief valve incorrectly the dealer adjusted Leakage in hydraulic system Contact...
Page 20
The inspections are to be performed on the basis of form no. B0278 and proved on form no. B0284. Forms and instructions for the inspections are available at your dealer. Ergonomic Lifting Performance Logitrans A/S +45 76 88 16 00 info@logitrans.com www.logitrans.com ELF-L-EN...