Advantech B+B SmartWorx SmartStart Start Manual page 8

4. Ethernet
An Ethernet cable may be connected to the ETH connector (designated as ETH0 in some
versions of this router) on the front panel (see figure above). By default, the Ethernet port is
configured as follows:
Connector Purpose
ETH LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
Configuration
1. Configuring the Device Using the Web Browser
You can access the router for status monitoring, configuration, and administration after
entering the IP address of the router into the web interface. The default router IP address is
192.168.1.1 (netmask 255.255.255.0). Configuration access is allowed for the user "root" with
the initial password "root". Attention, it is necessary to use HTTPS protocol for secure
communication over a network! For a detailed description and examples of the router con-
figurations, see the Configuration manual.
2. Configuration Settings via SmartWorx Hub
If your router has been pre-installed with the SmartWorx Hub client, you may configure it
from SmartWorx Hub. Navigate your browser to:
If this is your first time, please register with the site. If not, please login with your username
and password. Once logged in, further assistance can be found here:
https://hub.bb-smartworx.com/Login/Help?HelpFile=bbdms_help.pdf
3. Restoring and Backing up the Router Configuration
After you reset the router, the current configuration is overwritten by the default settings.
We recommend that you back up the router configuration before resetting the device. Refer to
the Configuration manual for more information.
https://hub.bb-smartworx.com
7
SmartStart
Default Setting
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
QSG issued in CZ, January 25, 2017