Table of Contents
Advertisement
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Using the system board holder and plunger , lower the system board leaning at an angle into the system.
3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
Figure 107. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
IDSDM module (if removed)
c.
Internal USB key (if removed)
d.
Expansion cards
e.
Cooling fan cage assembly
f.
Processor and heat sink module
g.
Memory modules
h.
OCP (if removed)
i.
OCP shroud
j.
Air shroud
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
Re-enable the Trusted Platform Module (TPM). See the
108
Installing and removing system components
Restoring the system by using the Easy Restore
section.
Upgrading the Trusted Platform Module
Manually
section.
Advertisement
Table of Contents
