Table of Contents
Advertisement
Figure 76. Disconnecting the BOSS power cable and signal cable
6. Using the Phillips #1 screwdriver remove the two M3 x 0.5 x 4.5 mm screws that secure the BOSS S2 module on the BOSS
module bay.
7. Slide out the BOSS S2 module from the BOSS module bay.
Figure 77. Removing the BOSS S2 module
8. Remove the BOSS power cable and BOSS signal cable from the BOSS S2 controller card module.
Figure 78. Removing the BOSS power cable and BOSS signal cable
84
Installing and removing system components
Advertisement
Table of Contents
