Table of Contents
Advertisement
Steps
1. Press the blue release tabs to disengage the drive backplane from the hooks on the system.
2. Lift the drive backplane out of the system.
NOTE:
To avoid damaging the backplane, ensure that you move the control panel cables from the cable routing clips
before removing the backplane.
Figure 45. Removing the drive backplane
Next steps
Replace the drive
backplane.
Installing the drive backplane
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4.
Remove the drive backplane
5.
Remove the cooling fan cage
6.
Remove the PERC
card.
7.
Remove the
drives.
NOTE:
To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before
removing the backplane.
NOTE:
Route the cable properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Use the hooks on the system as guides to align the slots on the backplane with the guides on the system.
2. Slide the drive backplane into the guides and lower the backplane until the blue release tabs click into place.
Safety
instructions.
Before working inside your
cover.
assembly.
system.
Installing and removing system components
55
Advertisement
Table of Contents
