Intrusion Switch Module; Removing The Intrusion Switch Module - Dell EMC PowerEdge E75S Series Installation And Service Manual

Figure 31. Installing the side wall bracket
Next steps
1. Install the air shroud.
2. Install the cooling fan cage assembly
3. Follow the procedure listed in the

Intrusion switch module

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Disconnect the system power cable from the system board.
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
44 Installing and removing system components
.
After working inside your
Safety instructions.
Before working inside your
system.
system.