Installing The Left Control Panel; Removing The Right Control Panel - Dell EMC PowerEdge E75S Series Installation And Service Manual

Installing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Align and slide the left control panel assembly in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to the connector on the system board .
5. Using the Phillips #1 screwdriver, tighten the screws to secures the left control panel and the cable cover to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 110. Installing the left control panel
Next steps
1. Install the cooling fan cage
2. Install the drive backplane
3. Install the air shroud.
4. Follow the procedure listed in the

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
112 Installing and removing system components
Safety instructions.
Before working inside your
assembly.
cover.
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.