Securing The On-Board Computer; Removing The On-Board Computer - Bosch KB060 KD Series Manual

6.5.17.7 Securing the on-board computer

It is possible to secure the on-board computer so
that it cannot be removed.
.
Figure 154: Position of headset screw
1 Undo headset screw (1) until the Kiox mount
can be swivelled sideways.
2 Insert on-board computer into the mount.
3 Fasten the blocking screw (M3, 6 mm long)
into its designated thread in the mount from
below. Never use a longer screw as this can
cause damage to the on-board computer.
4 Swivel mount back and fasten the headset
screw as per the manufacturer's instructions.
MY22K01 - 32_1.0_26.08.2021
All manuals and user guides at all-guides.com
1

6.5.17.8 Removing the on-board computer

 The on-board computer can be removed if it is
not secured.
.
Figure 155: Removing the on-board computer
1 Grip the on-board computer by its top edge.
2 Pull on-board computer towards you until on-
board computer comes out of the magnetic
mount.
 The system is switched off by removing the on-
board computer. Charging the on-board
computer battery.
You can recharge the on-board computer battery
either on the pedelec or via the USB port.
Operation
135