Bosch KB060 KD Series Manual page 214

8.5.8.4 Eightpins NGS2 seat post
Only applies to pedelecs with this equipment
Removing the seat post
1 Use a 2.5 mm hex key to turn the height
adjustment 45° anti-clockwise and move to the
"Open position".
Figure 206: Moving height adjustment to the "Open
position"
2 Activate operating lever. Pull seat post
upwards at the same time and remove
completely.
Figure 207: Pulling the seat post out
3 Activate operating lever. Hold Bowden cable
fastener and pull or tilt forwards. Remove outer
sleeve from the seat post remote control.
Figure 208: Removing the cartridge
4 Use a 5 mm to undo Postpin axle and pull out.
Figure 209: Undoing the Postpin axle
MY22K01 - 32_1.0_26.08.2021
All manuals and user guides at all-guides.com
5 Pull cartridge from the piston rod while pushing
Figure 210: Pulling the cartridge out
6 Hold the cartridge with one hand at the height
7 Hold the white actuating slide in the locking
8 Carefully push the Bowden cable upwards with
Figure 211: Detaching the Bowden cable
 Never pull Bowden cable forwards at an angle.
Figure 212: Bowden cable position
the outer sleeve into the frame at the same
time to help.
of the mechanism and pull the Bowden cable
straight down with the other.
mechanism with your thumb.
the other hand and detach it.
Notice
Maintenance
213