Bosch KB060 KD Series Manual page 219

9 Carefully insert slide bushing tube into the seat
tube.
Figure 237: Inserting the slide bushing tube into the seat
tube
10 Place outer sleeve on the seat tube and push
downwards firmly.
Figure 238: Attaching the outer sleeve
11 Turn the outer sleeve so that the outer sleeve
mounting hole is aligned with the fastening
hole in the frame.
12 Use a 3 mm hex spanner to fasten the M5
attachment screw into the outer sleeve.
13 Tighten screw gently with a maximum torque of
0.5 Nm.
 The screw must easily screw into the outer
sleeve without any resistance. If this is not the
case, the hole in the frame is not aligned with
the mounting hole in the outer sleeve. Turn
outer sleeve into the right position.
Figure 239: Fastening the outer sleeve
14 Feed height adjustment clamp into the seat
tube.
 The two height adjustment clamp guides are in
the longitudinal grooves inside the seat post.
MY22K01 - 32_1.0_26.08.2021
All manuals and user guides at all-guides.com
Figure 240: Feeding the height adjustment clamp in
15 Push the seat post carefully downwards and
Figure 241: Pushing the seat post downwards
 Never let the seat post tube collide with the
16 Move operating lever and press seat post
Figure 242: Setting the seat post height
17 Turn the height adjustment mechanism 45° in
Figure 243: Closing the height adjustment
feed into the wiper.
Notice
piston rod. There is a risk of scratches and
damage to the piston rod. This will causes loss
of air.
downwards to the required height as per the
values in the pedelec pass.
a clockwise direction and place in the "Closed
position".
Maintenance
218